1. The safe use of non-contact air regulator is as follows:
1. Before installation, check whether the capacity and load of the air stabilizer are reasonably matched, whether the mains voltage is within the allowable range of the air stabilizer, and whether the output voltage of the air stabilizer meets the equipment requirements;
2. The selection of the connecting wire of the air regulator must meet the stipulated connection wire that can carry sufficient current capacity;
3. During normal power-on and startup, please do not disassemble the air stabilizer or pull the input and output wires of the air stabilizer at will to avoid electric shock or other electrical safety accidents;
4. The input and output connection lines of the air regulator must be arranged reasonably to avoid trampling and wear, which may cause safety accidents caused by leakage;
5. The grounding of the air stabilizer must be safe and reliable. If the air stabilizer is directly operated without the grounding wire, it will cause personal injury such as electric shock;
6. The ground wire of the air regulator cannot be connected to public welfare facilities such as heating pipes, water supply pipes, gas pipes, etc., so as not to infringe the rights of third parties or cause other harm;
7. Regularly check the input and output connection wires of the air regulator to avoid loosening or falling off, which will affect the normal use of the air regulator and the safety of electricity;
8. Remember to handle the air regulator with care and avoid severe vibration when working;
9. Ensure that the carbon brush spring of the air regulator has sufficient pressure to avoid flashover on the contact surface of the carbon brush and the coil;
10. Non-professionals, please do not disassemble or repair the air regulator without permission;
11. Operate strictly in accordance with the operating instructions of the air regulator.
